24-volt default setting.\r\rIf not using seat switch \(Pin 5\), replace switch with jumper wire to B-.\r\rPin 4 should not be connected until after controller is turned on.\r\rController should be mounted to a paint free metal surface with thermal transfer grease.\r\rAccelerator potentiometer should travel from 0 to 5k for Min to Max speed.\r\rFuses are recommended in case of wiring short circuit.)
Pin 4 should not be connected until after controller is turned on.Ĭontroller should be mounted to a paint free metal surface with thermal transfer grease.Īccelerator potentiometer should travel from 0 to 5k for Min to Max speed.įuses are recommended in case of wiring short circuit.) main harness and only provides power to system when charger is unplugged from AC power source. According to Sevcon the Calibrator part number must be 662/14063. If not using seat switch \(Pin 5\), replace switch with jumper wire to B-. For those reading this thread Chuck and I have found out some information about the controller logic in his Sevcon PP745 PN 662S45622 with a SN starting 2004 that the Calibrator (programmer unit) I have Part Number 662/14031 will only read the settings not change them.
0 kommentar(er)
